The idle speed of EFI motorcycle needs to be adjusted by the following methods.

1. First start the motorcycle, find the corresponding screwdriver, and then find the position of the idle screw.

2. The pre adjustment is carried out immediately. The first thing to be adjusted is the screw of the throttle valve to ensure that the engine can run at the speed, and then the engine will not stop.

3. It is the adjusting screw to increase the speed of the starter as much as possible.

4. It is the screw for adjusting the throttle valve. At this time, the speed of the starter is required to decrease as much as possible.

It is the way to regulate the idle speed of EFI motorcycle. We need to know that if the belt speed of the motorcycle is too high, the vehicle will consume fuel. If the idle speed is low, it is possible to stall at high speed. It is also unfavorable for motorcycle riding, and the lubricating oil will be continuously reduced during the body cooling process. Therefore, do not think that low belt speed of the motorcycle will save fuel, which will also cause corresponding damage to the body.

If there is no way to measure it, you can contact the manufacturer of the motorcycle and ask special personnel to adjust it according to the manufacturer's standards. In addition, attention should be paid to protection during adjustment. Since the motorcycle is launched at this time, attention should be paid to avoid injury. In general, the collection of motorcycles is on the right side of the vehicle. There are many exhaust holes on the right side, as well as a series of important machines such as the starter box. Therefore, pay attention to protection during adjustment to avoid injury, and do not damage other lines. And if you want to adjust the idle speed of the motorcycle, control it to 300~500. Because the scale of adjustment cannot be too high or too low. Therefore, the standard is met within 300~500.

Article source: EFI motorcycle system www.sailifu.cn